G-Technology G-Speed eS Pro Guia do Utilizador descarregar pdf (Página 14)

p.14

Using the ATTO RAID Controller

Download ATTO RAID Software

To use the ATTO R680 RAID controller, you rst need to install drivers and software

on your system. Visit www.g-technology.com/support/gspeed_es_pro/

Here you will nd a special link to the ATTO website where you can download

G-Tech approved drivers and software. You will also nd the latest verison of this

manual and easy conguration scripts for quickly setting up your G-SPEED eS Pro

with the ATTO controller.

From the G-Tech page* on the ATTO website, please

download the following items:

• Driver for your system

• CongTool utility

• ATTO R680 User Guide (optional)

* The software listed on the ATTO/G-Tech page has been tested

and approved for use with G-SPEED eS Pro. Software listed on

the standard download page on the ATTO website may not be

compatible with G-SPEED eS Pro.

Install ATTO Driver & CongTool

G-SPEED eS Pro comes pre-congured for use with the ATTO R680 RAID controller.

The drive is set up in RAID 0 and formatted for Mac OS X. Connecting G-SPEED eS

Pro to your Mac Pro and conguring your system takes just a few steps as outlined

below. (Windows users, please refer to the ATTO R680 User Guide.)

1. Locate the driver and CongTool downloaded

from the ATTO/G-Tech page and install the driver,

then CongTool.

2. The ATTO CongTool can notify you if problems

occur with the G-SPEED eS Pro. If you would like

to use this feature, select ‘Full Installation’.

3. Shut down your system.

download

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 50 51

Sem comentários

G-Technology G-Speed eS Pro Guia do Utilizador Página 14